Q-Logic SN0135524-00 Manual de usuario descargar pdf (Pagina 104)

Cisco SN 5428 Storage Router

QLogic Specific Configuration

AGE 92 QLOGIC SWITCH INTEROPERABILITY GUIDE

VERSION 1.0, MARCH 2003

Cisco CLI

NOTE: Use the following CLI commands when the Cisco SN 5428 Management Interface is not

available.

ATTENTION!!

This procedure requires a reboot of the switch.

CISCO SN 5428 Storage Router

Password: *****

[Cisco_5428]$ ena

Enter admin password: *****

[Entering Administrator mode]

[Cisco_5428]# interface fc domainid zoning merge sw2

*[Cisco_5428]# save all bootconfig

QLogic Specific Configuration

Not applicable.

Successful Integration Checklist

Perform the following steps after the E-port connection has been established and the fabric has

had time to update. If everything verifies, the Cisco and QLogic fabrics have successfully merged.

✓ Compare and verify that all Zoning information has been propagated on all switches.

✓ Verify that the correct Zone Set is activated.

✓ Compare and verify that all devices are in the Name Server of each switch.

✓ Verify that all initiators continue to detect and have access to all targets that existed prior to the

fabric merger.

After everything is verified, your fabric has merged successfully and no additional steps need to

be taken. If any of the above tasks did not complete successfully, please contact QLogic support.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 319 320

Sin comentarios

Q-Logic SN0135524-00 Manual de usuario Pagina 104