Q-Logic 64 Manual de usuario descargar pdf (Pagina 175)

B – Command Line Interface

Set Config Command

59043-03 A B-53

Finished configuring attributes.

This configuration must be saved (see config save command) and

activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command.

The following is an example of the Set Config Zoning command.

SANbox2 #> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config zoning

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list press 'q'

or 'Q' and the ENTER key to do so.

FC-SW-2 AutoSave (True / False) [True]

Default Visibility (All / None) [All ]

Finished configuring attributes.

This configuration must be saved (see config save command) and

activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 243 244

Sin comentarios

Q-Logic 64 Manual de usuario Pagina 175