Q-Logic 64 Manual de usuario descargar pdf (Pagina 104)

6 – Removal/Replacement

I/O Blades

6-10 59043-03 A

10. Verify the POST results. The I/O blade diagnostic status appears in the

dialog. The status should be "Passed".

Hotswap IO blade process successfully completed.

Diagnostics has been run on the IO blade in slot 6: Passed

11. The system checks the I/O blades for matching Zircon processor firmware. If

any of the I/O blades are not compatible, an alarm message will be

generated indicating that a Zircon firmware mismatch has occurred. To

display the alarm messages, enter the Show Alarm command or use the

SANbox Manager event browser. Refer to ”Show Command” on page B-63

for more information. If a mismatch does occur, contact your authorized

maintenance provider.

SANbox2-64 #> show alarm

[9][Wed Jan 16 13:32:19.500 2003]

[A4101][0xdd0072c2.329][IO-1 Zircon firmware mismatch:

rev 0.5, should be perhaps rev 0.7]

Note: A “Failed” status could indicate a faulty blade or module. Enter

the Show POST Log command for more information or contact

your authorized maintenance provider.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 243 244

Sin comentarios

Q-Logic 64 Manual de usuario Pagina 104